HALL claw lacings are available in two versions:

HALL claw lacing
The universal lacing with variable width.

HALL claw lacing with center plate
On tracks with reduced cleat spacing the cleat is mounted on the center plate. The
movable lacing components are therefore located to the right and left of the cleat.
The required lengths can be broken off from the strip lacing. Single lacings can al-
so be used and connected in the lacing tool.

With the HALL principle it is easy to replace any damaged lacings in the belt.

 
 

Available products

HALL claw lacing
Lacings in packs of 10 strips
 with a length of 8.78"

HALL lacing bolts
4.68", 5.85", 8.58"
and 9.36" in length

Center plates suitable for all
common band widths


 

HALL 3-hole center plates
7.8", 8.39" and 9.97" wide

 

HALL 2-hole center plates
4.49", 4.88" and 5.66" wide
HALL plate lacings are available in two and three section versions with central plate.
With a plate thickness of 0.12" they are designed for the toughest mountain conditions
and selected for the respective belt width. Galvanized, hinge screws with washers and
securing nut.
 

Available products

HALL plate lacing 2-section
For belt widths of 9.36" and 4.68"

HALL plate lacing 3-section
For belt widths of 9.36" and 4.68"

HALL plate lacing 3-section
For belt widths 8.58" and 5.85"
(Kässbohrer standard)

Special widths upon request

 

Overlapping lacings
With this type of lacing, the belts are
screwed with a base plate and with
headless screws and a back plate
with crimp nuts. Available for all
common belt widths.



Overlapping lacings